Digital Link DL600E E1 Uživatelská příručka stáhnout pdf (Strana 100)

5-10 Solo E1 DSU User Guide—June 1998

Pattern Tests

Table 5-2 contains a list of these pattern tests.

The QRW Test

QRW (Quasi Random Word) is a pseudo random signal which catches

problems not exposed by other test patterns. The DSU/CSU transmits a

QRW pattern to the E1 network, the remote system loops it back to the

DSU/CSU which monitors the signal for QRW bit errors.

You can also use the QRW code to isolate a E1 network problem to a

speciÞc transmission direction. In this case, both E1 transmission directions

are monitored when the local and the remote system transmit QRW (the

remote is not put into loopback).

This test is available on any fraction of the E1.

To simulate live trafÞc, QRW testing is strongly recommended.

The Send 1:7 Test

This pattern stresses the timing recovery circuits of repeaters and other

intermediate equipment.

The Send 3:24 Test

This pattern tests for 1s density (consecutive zeros) tolerance on AMI lines.

The Send 1:1 Test

This pattern sends alternate 1s and 0s to test for bridge taps.

The Send All Ones Test

This pattern is used for signal power measurements. All 1s simulates the

highest spectral components and the highest energy out of the DSU/CSU

and out of the line repeaters on the E1 line.

The Send All Zeros Test

This pattern checks the correct operation of the HDB3 (E1) line coding.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 139 140

Žádné komentáře

Digital Link DL600E E1 Uživatelská příručka Strana 100